Overview — Zamp Remote Digital Display (RT1)
PART NUMBER: ZS-RT1
Keep an eye on your batteries and power levels from your bedroom, office, or living space with our remote digital display. Its 23-foot wire mean it can be mounted anywhere inside your RV, boat, or cabin where it’s most visible and convenient for you.
This display provides all the same information as the charge controller—battery voltage, charging current, charging capacity (amps per hour), battery types, full charge, and system faults—and its colored LEDs indicate operational status and battery conditions.
*Compatible only with our 30-amp charge controller, and comes included with the purchase of our 60-amp charge controller.
Resources — Zamp Remote Digital Display (RT1)
Documents — Zamp Remote Digital Display (RT1)
🎖️ Zamp ZS-RT1 Warantee 📏 RV Sizing Chart 📄 Zamp ZS-RT1 Spec SheetVideos — Zamp Remote Digital Display (RT1)
🇺🇸 Zamp, US-Made Solar Panels 🏆 Introducing Zamp ZS-RT1 📽️ Zamp Solar — StoryWarranty — Zamp Remote Digital Display (RT1)
✓ OffGrid Harbor is an Authorized Zamp Solar Dealer
✓ Includes all applicable Manufacturer Warranties
✓ Ships direct from manufacturer
✓ Additional Lifetime support from our specialists
FAQs — Zamp Remote Digital Display (RT1)
Q: Can I connect two charge controllers to the same battery bank (e.g. combine a roof mount system and a portable kit)?
Answer: Yes, two independent charge controllers can be connected directly to the battery as long as both controllers are set to the same battery type.
The charge controllers will not work properly if wired in series, one to the other.
Q: Is the Zamp Solar port reverse polarity?
Answer: No, but they are different from other brands of solar ports because all of our SAE plugs are polarity-protected for safety reasons. That means the positive pin on all of our SAE plugs is set back and covered to prevent accidental contact that could damage your panel, short your battery, or give you a pretty nasty shock. So, because of the polarity protection on our plugs, Zamp Solar ports are only compatible with Zamp Solar SAE plugs.
Q: What does the b01 601 error message on my charge controller mean?
Answer: This common error code means the charge controller can’t see the battery bank. The most common cause of this is a bad connection between the charge controller and the battery bank
Q: Why isn’t my solar system charging my battery?
Answer: When a solar system isn’t working, the most common culprit is a wiring problem. Our troubleshooting document can help you identify the disconnect and get it fixed. If you’re still having issues, please contact us for further assistance.
Q: What batteries should I use?
Answer: Any type of 12-volt deep cycle battery (lithium, gel, AGM, conventional lead-acid (wet), and calcium) will work with your Zamp Solar system. If you choose to go with two 6-volt batteries, make sure that you use two of them wired in series to create a 12-volt battery bank.
Q: What size kit do I need to power my RV?
Answer: Everybody’s needs are different, but we can certainly provide some insight into what size solar kit typically works for various sizes of RVs. Check out our infographic to see which of our kits might work best for you.
Q: I have a Zamp Solar Ready sticker on the side of my RV, what does that mean?
Answer: If an RV is “solar ready,”it means that the RV came pre-wired for our solar products with either a 3-port roof cap, a single port roof cap, or a side-wall port. However, each manufacturer does it slightly differently—some include full wiring, while others only wire from the roof to the batteries.