Overview — Zamp 115 Watt Complete Kit
PART NUMBER: KIT1003
This small solar kit is enough to charge most single 12-volt batteries, making it a perfect introduction to a solar-powered lifestyle. Excellent for smaller trailers or over-the-cab truck campers, it can also expand up to 510-watts for larger rigs and equipment.
This Kit Includes:
30 Amp, 5-stage PWM Charge Controller
Pre-Assembled wiring harness
3-port roof cap (ready for future expansion)
Stainless steel mounting hardware
Panel Specs: (Download Techincal Spec Sheet)
39.6" x 26.5" x 1.5"
115-Watt Power Output
Generates 6.3 amps
25-Year output warranty
- Comes with 10' quick connect SAE leads
Resources — Zamp 115 Watt Complete Kit
Warranty — Zamp 115 Watt Complete Kit
✓ OffGrid Harbor is an Authorized Zamp Solar Dealer
✓ Includes all applicable Manufacterer Warranties
✓ Ships direct from manufacterer
✓ Additional Lifetime support from our specialists
FAQs — Zamp 115 Watt Complete Kit
Q: Can I connect two charge controllers to the same battery bank (e.g. combine a roof mount system and a portable kit)?
Answer: Yes, two independent charge controllers can be connected directly to the battery as long as both controllers are set to the same battery type. The charge controllers will not work properly if wired in series, one to the other.
Q: Is the Zamp Solar port reverse polarity?
Answer: No, but they are different from other brands of solar ports because all of our SAE plugs are polarity-protected for safety reasons. That means the positive pin on all of our SAE plugs is set back and covered to prevent accidental contact that could damage your panel, short your battery, or give you a pretty nasty shock. So, because of the polarity protection on our plugs, Zamp Solar ports are only compatible with Zamp Solar SAE plugs.
Q: What does the b01 601 error message on my charge controller mean?
Answer: This common error code means the charge controller can’t see the battery bank. The most common cause of this is a bad connection between the charge controller and the battery bank
Q: Why isn’t my solar system charging my battery?
Answer: When a solar system isn’t working, the most common culprit is a wiring problem. Our troubleshooting document can help you identify the disconnect and get it fixed. If you’re still having issues, please contact us for further assistance.
Q: What batteries should I use?
Answer: Any type of 12-volt deep cycle battery (lithium, gel, AGM, conventional lead-acid (wet), and calcium) will work with your Zamp Solar system. If you choose to go with two 6-volt batteries, make sure that you use two of them wired in series to create a 12-volt battery bank.
Q: What size kit do I need to power my RV?
Answer: Everybody’s needs are different, but we can certainly provide some insight into what size solar kit typically works for various sizes of RVs. Check out our infographic to see which of our kits might work best for you.
Q: I have a Zamp Solar Ready sticker on the side of my RV, what does that mean?
Answer: If an RV is “solar ready,”it means that the RV came pre-wired for our solar products with either a 3-port roof cap, a single port roof cap, or a side-wall port. However, each manufacturer does it slightly differently—some include full wiring, while others only wire from the roof to the batteries.
Q: How do I clean Zamp Solar panels?
Answer: We recommend to use a mixture of warm water and a good quality automotive soap applied with a soft cloth twice a year or more depending on your location. Do not use any harsh chemicals or a power washer when cleaning the panels as this could damage the anti reflective coating applied to the glass.