Overview — PrecisionTemp TwinTemp-2 Natural Gas Tankless Water Heater
Two different heating zones and up to eight blowers. Whisper quiet operation and no diesel smell.
- On-demand Hot Water & Hydronic Heat
- Designed specifically for RVs, Trailers, Tiny Houses, Cabins, and more
- Whisper-quiet operation and no diesel smell
- Dimensions 20.5” wide X 16” deep X14”high
- Weight 70 pounds
- No pilot light and 35% higher efficiency
- Fully certified to ANSI Z21.10.3/CSA 4.3 standards
- 55,000 BTU burner and two 1,500 watt electric element and two independent heating zones
- No sidewall penetration Lighter, compact design that saves space and gas usage
Resources — PrecisionTemp TwinTemp-2 Natural Gas Tankless Water Heater
Documents — PrecisionTemp TwinTemp-2 Natural Gas Tankless Water Heater🛠Installation Manual
Videos — PrecisionTemp TwinTemp-2 Natural Gas Tankless Water Heater🎥 Precision Temp Installation
Warranty — PrecisionTemp TwinTemp-2 Natural Gas Tankless Water Heater
✓ OffGrid Harbor is an Authorized PrecisionTemp Dealer
✓ Includes all applicable Manufacturer Warranties
✓ Ships direct from manufacturer
✓ Additional Lifetime support from our specialists
Features — PrecisionTemp TwinTemp-2 Natural Gas Tankless Water Heater
Unlike diesel-only tankless water and hydronic heaters, the TwinTemp runs on natural gas and can be used in all motorhomes, fifth wheels, horse trailers and towables.
Dual-Source Unlimited Heat
With a 55,000 BTU natural gas burner—the highest hot water output in the industry—and two 1500-watt electric elements, the TwinTemp-2 delivers on-demand, continuous hot water and hydronic space heating.
More Hot Water and Heat. Less Natural Gas.
With higher efficiency and 55,000 BTUs, the TwinTemp-2 produces more hot water than traditional water heaters.
Specs — PrecisionTemp TwinTemp-2 Natural Gas Tankless Water Heater
|Type||Gas instantaneous, power vent water / space heater.Full gas modulation temperature control.Certified to UL 307A & ANSI Z21.10.3|
|Dimensions||20.5″ Wide x 16″ Deep x 14″ High.|
|Hook-ups||Gas, brass 3/8″ flare.Water and heating lines 1/2″ FTP brass.DC Electric, 12-2×2′ lead . 110VAC – 14-3 SJO plug|
|Capacity||Gas 55,000 BTUs input – 44,500 BTUs output @ maximum burn at 8.5 WCI manifold pressure.15,000 BTUs input – 12,500 BTUs output @ low burn at 1.2 WCI manifold pressure (88° F temperature rise / gallon / minute continuous flow at high burn).Two 1,500 Watt/5,100 BTU-110 Volt elements.|
|Gas Train||Burner: 12 element high primary air, atmospheric type with stainless steel construction.Orifices: Brass # 71 x 12.Gas Valve. Redundant solenoid with integral regulator|
|Water Assembly||Heat exchangers: solid copper, Hook- ups, 1/2″ OD copper tubes.Water line – brazed hard copper.PRV: Approved set @ 25 PSI.Optional: Engine Assist and Hot Tap Dispenser.|
|Venting||Power vent, proofing, terminating to 2” exhaust through floor of vehicle.|
|Construction||Powder coat aluminum case.Modular – 3 assemblies – gas, electronics and water.Case and flue assembly are 18 gauge welded steel.Component access is through front access panel.|
|Fuel||Natural Gas at 11 WCI Power: 12 VDC at 4.5 Amp full operation. (Operating range 10.5 – 15 VDC)|
|Flue Gas Temperature||Under 300° F|
|Water Temperature||Potable water is tempered and temperature can be field adjusted for 100-145 degrees F.HotTap: Minimum 180° F.|
|Mounting||Flange mounts that screw to coach floor.Must be mounted in accordance with local codes or in absence of local codes: Manufactured Home Standard, Title 24 CFR, Part 3280 or Recreational Vehicle Standard ANSI A 119.2/NFPA501C|
|Safety Features||Pilotless.Flame rectification.Gas valve shuts off in .8 second if there is a flame outage.Redundant gas solenoid.Electronic high temperature shut-off (two).ECO high temperature shut off at 212°F with auto reset.Pressure relief valve @ 25 PSI.Power vent with proofing.|
|Disclaimer||Due to continuous product improvement, PrecisionTemp reserves the right to change specifications at any time.|